Apron Skid - Cooling Bed Charging Mechanism

Charging Bar Tyoe: Deformed Rebar ,  Round Bar， Angle Bar,           Channel Bar, H-Beam,          ETC...

Charging Bar Size :           8 - 40mm,                             #4 - #15             , 80 - 230

Transmision  Type:  Hydraulic / Pneumatic

Cooling bed length : 18 mtr - 120 mtr

Cooling bed width  : 5 mtr - 12 mtr

Bar Rolling Charging Speed : 8 - 30 m/s

Charging to the Cooling Bed : 3 - 8 sec / cycle

The apron guide system in the apron cooling bed steel equipment of the production line is often unstable. The bevel, large side and pin holes of the skirt are seriously worn, and the long shaft system of the skirt is vibrating greatly.

By reducing the elevation of the accelerating roller surface, the downward motion of the skirt plate is increased by 40mm, which solves the problem of the steel bar jumping out of the groove. The service life of the skirt bevel and the large side, the guide bevel and the single-tooth straightening plate are increased by grooving alloy strips. The vibration of the skirt long axis system is reduced by moving the support of the skirt cylinder close to the lower support of the roller table beam. The maintenance time of skirt system is reduced and the operation rate is increased.

The cooling bed is one of the indispensable auxiliary equipment for small and medium-sized bar workshops. Its function is to cut the bar of multiple feet length by flying shears after rolling mill, transport and unload it to the cold bed rack for cooling, so that its temperature is reduced from 900℃ to 100 ~ 300℃, and then collected by the cold bed feeding device and sent to the output roller, and then sent to the output roller to the cold shear cut into a size of finished products. The design quality and installation accuracy of the cold bed directly determine the final quality of the product.

• Run- In Roller Tables – having apron type diverters or twin channels as bar delivery systems.
• Aligning Roller Table – for uniform alignment of bar ends.
• Transfer out Device / Layer Transfer – For transferring bars after Alignment to Run Out Roller Table.
• Run Out Roller Table: For Feeding the Bars to Cold Shear.